Our bare rooted products that are up to 90cm (3ft) may be ‘Notch’ planted by making two vertical notches at right angles with a spade, opening up the notch and inserting the plant in the soil. This should be no deeper than the plant has already been growing.

Larger plants should be pit-planted, by removing a square of soil and spreading the roots well out in the pit before back filling with soil. Add compost if the soil is poor.

If you are using a tree shelter then place this carefully over the planted tree and secure with a stake. Where rabbit spirals are used, insert a bamboo cane alongside the plant to provide stability. Ensure that the plant is well firmed in.

If you are planting root-balled trees loosen the top but do not remove the netting or mesh.

It is important to eliminate all weeds around each plant using a contact herbicide such as glyphosate. This can be done quite effectively by a polythene or organic mulch.

When using any spray always follow the manufacturer’s recommendations.

All trees and plants should be watered regularly, particularly during prolonged dry spells.

Information and step by step Instructions on how to plant a standard tree

 

  • Planting takes place between November and March while the tree is dormant and leafless. Avoid frozen or waterlogged ground.

 

  • Always keep the roots covered and in the co-extruded forestry bag in which they were supplied until you are ready to place the tree into the hole.

 

  • Frost may kill your tree if the roots are left exposed.

 

 

    Site Preparation

  • Clear the site: Remove all grass and weeds in a 1m square around the planting spot.
  • Size the hole: Dig a hole that is wide enough to spread the roots out comfortably without bending them, matching the depth of the root system. A square hole works well, especially in clay soil, to stop roots from circling.
  • Check the depth: Ensure the root flare (the soil mark on the trunk where the roots start) or graft union stays 1 to 2 inches (5 cm) above ground level so the tree does not sink too deep, or become overplanted. (Beech particularly hate overplanting).

    Staking (Crucial for Standard Trees)

  • Install the stake: Drive a sturdy wooden stake into the ground before or during planting on the windward side, avoiding piercing the root system.
  • Positioning: Angle it at about 45 degrees or keep it vertical, ensuring it sits low enough (just below the first main branches) so the trunk does not rub against it.
  • Secure the tree: Use a flexible rubber or buckle tree tie with a spacer, set in a figure-eight shape, to hold the trunk firmly without choking it.

    Planting and Backfilling

  • Backfill: Fill the hole with the excavated topsoil (mixed with a little well-rotted compost if needed). Gently shake the trunk as you backfill to let soil filter into the roots and eliminate air pockets.
  • Firm the ground: Gently firm the soil around the base with your heel to anchor the tree and prevent "wind-rock".

    Aftercare

  • Install a mulch mat around the base of the tree to surpress weeds, anchor with 5 pegs (one for each corner and one to secure the closure)
  • Water: Give the tree a generous watering immediately after planting.
  • Mulch: Apply a 5–8 cm (2–3 inch) layer of organic mulch (like well-rotted compost or wood chips) around the base to retain moisture and block weeds. Leave a small gap around the bark so it does not touch the trunk directly.
  • Protection: Add a spiral tree guard to protect the young bark from rabbits or small rodents.
  • Maintenance: Water regularly during dry spells over the first two growing seasons, check and loosen ties annually, and the stake can be removed after 2 to 3 years once the roots are self-supporting.

 

Â